Question 1

A time-of-use (TOU) template's interval size controls the values allowed as start and end times. A template can be used to generate TOU data for TOU maps whose seconds per interval (SPI) is divisible by the template's SPI. For what can you use a 60-minute template?

Options :

A : To only generate TOU data for 30-minute TOU maps.

B : To generate TOU data for 6G-, 15-, and 5-minute TOU maps.

C : To generate TOU data for 120-minute TOU maps.

D : To only generate TOU data for minute TOU maps.

E : To generate TOU data for 120-minute and 1440-minute TOU maps.

Answer: D

Question 2

At which stage during the high-level process of loading interval initial measurement data does Meter Data Management (MDM) normalize measurements and why?

Options :

A : Validation, Estimation, and Editing (VEE) stage, so that each interval can be compared to a specific date and time for validation.

B : Create the Final Measurements stage, so that each interval measurement is stored as a single record for a specific date and time.

C : Load the Initial Measurements stage, so that each interval measurement is stored as a single record for a specific date and time.

D : Create the Final Measurements stage, so that each interval is stored as the adjusted value to represent an average interval value.

Answer: B

Question 3

Which statement is true about usage transaction?

Options :

A : It is created by an external source or Meter Data Management (MDM), which uses the usage calculation engine to generate usage values.

B : It is created by an external source or MDM, which uses the usage calculation engine to generate a final value. Valuation, Estimation, and Editing (VEE) can be configured but when called in real time, usage transaction may not be saved.

C : It must be created by an external system and it must be stored in the database.

D : It is created by an external source or MDM, which uses the usage calculation engine to generate a final value. VEE can be configured and usage transaction is saved.

Answer: D

Question 4

A customer is starting an Advanced Meter Infrastructure (AMI) roll-out initiative and they plan to replace their legacy scalar time-of-use (TOU) meters with smart meters. They want customer information system (CIS) to continue to bill for the same TOU periods and they do not want to change the CIS rates.

In which THREE ways can you configure Meter Data Management (MDM) to support this requirement?

Options :

A : Write a custom algorithm to determine the proper rate.

B : Add an extendable lookup value containing the new device configuration type and the new usage calculation group.

C : Add the TOU mapping rule to the existing usage calculation group.

D : Add a new usage calculation group with a TOU mapping rule.

E : Set up the new usage calculation group to be identified dynamically by plug-in logic supplied on the usage subscription-s type.

Answer: A,B,C

Question 5

Initial measurement data (IMD) is imported into Meter Data Management (MDM) and can be viewed through the Measuring Component portal, but is not in the "Final" measurement status. What has the IMD passed in this case?

Options :

A : Critical validation

B : Multiplier check validation

C : Critical validation, high/low check validation, and sum check validation

D : High/low check validation

E : Sum check validation

Answer: A

Higher Test Marks with Free Online 1Z0-1091-24 Exam Practice

Buying Options: