Question 1

Which feature is required for IPv6 Source Guard to block traffic arriving on the server interface from unknown sources?

Options :

A : Dynamic ARP Inspection

B : IPv6 ND Inspection

C : DHCPv6 Guard

Answer: B

Question 2

Refer to the exhibit.

Redistribution is enabled between the routing protocols, and nowPC2 PC3, and PC4 cannot reach PC1. What are the two solutions to fix the problem? (Choose two.)

Options :

A : Filter RIP routes back into RIP when redistributing into RIP in R2

B : Filter OSPF routes into RIP FROM EIGRP when redistributing into RIP in R2.

C : Filter all routes except RIP routes when redistributing into EIGRP in R2.

D : Filter RIP AND OSPF routes back into OSPF from EIGRP when redistributing into OSPF in R2

E : Filter all routes except EIGRP routes when redistributing into OSPF in R3.

Answer: A,C

Question 3

Refer lo lhe exhibit. The Customer Edge rouler wants to use AS 100 as the preferred ISP for all external routes and ISP-2 as a backup.

After this configuration, all the backup routes have disappeared from the BGP table on the Customer Edge router. Which set of configurations resolves the issue on the Customer Edge router?

Options :

A :

B :

C :

D :

Answer: C

Question 4

Refer to Exhibit:

AS 111 wanted to use AS 200 as the preferred path for 172.20.5.0/24 and AS 100 as the backup. After the configuration, AS 100 is not used for any other routes. Which configuration resolves the issue?

Options :

A :

route-mmap SETLP permit 10 match ip address prefix-list PLIST1 set local-preference 99 route-map SETLP permit 20

B : route-map SETLP permit 10

match ip address prefix-list PLIST1

set local-preference 110

route-map SETLP permit 20

C : router bgp 111

no neighbor 192.168.10.1 route-map SETLP in

neighbor 192.168.10.1 route-map SETLP out

D : router bap 111 no neighbor 192.168.10.1 route-map SETLP in

neighbor 192.168.20.2 route-map SE TLP in

Answer: A

Question 5

Refer to the exhibit.

AS65510 iBGP is configured for directly connected neighbors. R4 cannot ping or traceroute network 192 168.100.0/24 Which action resolves this issue?

Options :

A : Configure R4 as a route reflector server and configure R1 as a route reflector client

B : Configure R1 as a route reflector server and configure R2 and R3 as route reflector clients

C : Configure R4 as a route reflector server and configure R2 and R3 as route reflector clients.

D : Configure R1 as a route reflector server and configure R4 as a route reflector client

Answer: D

Higher Test Marks with Free Online 300-410 Exam Practice

Buying Options: