Question 1

300-615-page127-image3

Refer to the exhibits. A switch is downgraded to an earlier release because of a problem with the current

release. After the switch is downgraded, it cannot forward traffic. Which action resolves the issue?

Options :

A :

Enable ISSD after the downgrade is complete.

B : Roll back to the original image.

C :

Reload the switch.

D : Shut and no shut the interfaces to the FEX.

Answer: B

Question 2

Refer to the exhibit.

Other-Image-28817ea11-3d60-409f-b77f-407eb87aaf5a

Refer to the exhibit. The monitoring team reports an inability to access the devices after a new centralized management integration. Which action resolves the issue?

Options :

A : Modifly the SNMP ACL to allow the incoming request packets.

B : Enable SHA authentication for the admin user.

C : Update the community string.

D : Change the admin user permissions to write.

Answer: C

Question 3

An engineer removes a VMM domain from an endpoint group called “EPG-1”, but the distributed port group

fails to be deleted. Which action resolves the issue?

Options :

A : Manually remove the port group.

B : Migrate all virtual machines in the EPG-1 to different hypervisors.

C :

Remove the remaining EPGs from the VMM domain.

D :

Migrate all virtual machines in the EPG-1 to different port groups.

Answer: C

Question 4

Refer to the exhibit.

An administrator directly connects a Fibre Channel storage array to ports 1 through 4 on a Cisco UCS 6454 Fabric Interconnect. The administrator configures a service profile to boot directly from the new Fibre Channel storage array, but the service profile fails to boot. When the administrator checks the output of the show flogi database command on the fabric interconnect, it shows the output presented in the exhibit. Which action resolves the issue?

Options :

A : Configure the Zoning Type in vHBA Initiator Group as Multiple Initiator Single Target.

B : Configure the fabric interconnects in Fibre Channel switch mode.

C : Configure the Zoning Type in vHBA Initiator Group as Multiple Initiator Multiple Target.

D : Configure the fabric interconnects in Fibre Channel end-host mode

Answer: B

Question 5

300-615-page127-image31

Refer to the exhibit. A network engineer is configuring the FCoE N_Port virtualization storage area network.

After the initial implementation, server 11 fails to connect to the disk array. Which action resolves the issue?

Options :

A : On MDS interface vfc 1/1, change switchport mode configuration to VF

B :

On N9K interface vfc11, change switchport mode configuration to NP

C :

On N9K interface vfc11 and MDS interface vfc 1/1, change switchport mode configuration to F

D :

On N9K interface vfc11 and MDS interface vfc 1/1, change switchport mode configuration to E

Answer: D

Higher Test Marks with Free Online 300-615 Exam Practice

Buying Options: