Question 1

A situation causes a fault to be raised on the APIC. The ACI administrator does not want that fault to be raised because it is not directly relevant to the environment. Which action should the administrator take to prevent the fault from appearing?

Options :

A : Under System -> Faults, right-click on the fault and select Acknowledge Fault so that acknowledged faults will immediately disappear.

B : Create a stats threshold policy with both rising and falling thresholds defined so that the critical severity threshold matches the squelched threshold.

C : Under System -> Faults, right-click on the fault and select Ignore Fault to create a fault severity assignment policy that hides the fault.

D :

Create a new global health score policy that ignores specific faults as identified by their unique fault code.

Answer: C

Question 2

An engineer must configure Cisco ACI for VMM integration to VMware vCenter. Which two attributes must be configured on the Cisco APIC to achieve this goal? (Choose two.)

Options :

A : cluster name

B : virtual switch name

C : data center name

D : port group

E : logon credentials

Answer: B,E

Question 3

Which two protocols are used for fabric discovery in ACI? (Choose two.)

Options :

A : LLDP

B : OSPF

C : CDP

D : DHCP

E : ISIS

Answer: A,D

Question 4

An engineer configures port-12 on Leaf-101 and Leaf-102 to connect to a new server called SVR-12. This server will belong to a new EPG-12 and needs to use Encapsulation VLAN-12. An already existing server, which is named SVR-10, is also connected to the same leaf switches. SVR-10 belongs to EPG-10 and also uses Encapsulation VLAN-12. Which step must the engineer take to configure connectivity for SVR-12 and EPG-12?

Options :

A : Associate EPG-12 to the same BD as EPG-10.

B : Enable port local VLAN scope.

C : Disable native VLAN on both EPGs.

D : Assign the IP address of SVR-12 to a different subnet.

Answer: B

Question 5

Refer to the exhibit. A systems engineer is implementing the Cisco ACI fabric. However, the Server2 information is missing from the Leaf 101 endpoint table and the COOP database of the spine. The requirement is for the bridge domain configuration to enforce the ACI fabric to forward the unicast packets generated by Server1 destined to Server2. Which action must be taken to meet these requirements?

Options :

A : Enable ARP Flooding

B : Set L2 Unknown Unicast to Flood

C : Set IP Data-Plane Learning to No

D : Enable Unicast Routing

Answer: B

Higher Test Marks with Free Online 300-620 Exam Practice

Buying Options: