Question 1

Which of the following statements is false?

Options :

A : VPLS is a bridged LAN service

B : VPLS provides L2 VPN services to CEs

C : VPLS is a point-to-point service where CEs are presented with point-to-point virtual circuits.

D : CEs that are members of the same VPLS service instance communicate with each other as if they are connected via a bridged LAN.

Answer: C

Question 2

Consider a large metro-to-metro VPLS network interconnected with a mesh of mesh-SDPs. Which of the following statements does NOT apply to this situation?

Options :

A : Bandwidth and replication inefficiency can occur on inter-metro links if there is a lot of multicast traffic

B : The number of control sessions grows exponentially in a fully meshed network

C : Spanning-tree is required to prevent loops when using mesh SDPs on the inter-metro links.

D : Network touches increase with each node added to the mesh.

Answer: C

Question 3

Click on the exhibit below.

A new router named PE-D is to be directly connected to PE-C and is required to be added to the existing VPLS

300. The design requires the least amount of signaling, the least amount of configuration changes for existing

sites and the new site has to have access to all existing sites. How should the new site be added to VPLS 300?

Options :

A : Configure a mesh-sdp between all existing PE routers and the new PE router

B : Configure a mesh-sdp between PE-C and PE-D

C : Configure a spoke-sdp between PE-C and PE-D.

D : It is not possible to meet the design requirements.

Answer: C

Question 4

Click on the exhibit below.

Assume PE-B expects avian tag as part of the RFC 4762 (Martini) encapsulation. How must PE-A be configured?

Options :

A : The port that the SAP belongs to must have the correct ether type configured.

B : The SAP must be configured with the right VLAN tag

C : The SDP VC type must be configured as type VLAN and the correct vlan-vc-tag must be specified

D : All of the above.

Answer: C

Question 5

Which of the following needs to be considered when designing Ethernet networks with redundancy?

Options :

A : Processing the TTL takes extra time

B : MAC learning rate is doubled.

C : FDB size is doubled

D : Requires a protocol to remove loops

Answer: D

Higher Test Marks with Free Online 4A0-105 Exam Practice

Buying Options: