Question 1

A combination of corrosion and erosion results in significantly greater metal loss that can be expected from corrosion or erosion alone. This type of loss occurs at

Options :

A : high-velocity and high-turbulence areas

B : areas where condensation or exposure to wet hydrogen sulphide or carbonates occur

C : surface-to-air interfaces f buried piping

D : areas where gradual loss of material occurs because of a corrosive medium

Answer: A

Question 2

A welder continuity log should be maintained to allow verification that each welder has utilized each welding

process within a _______ period.

Options :

A : one year

B : 3 month

C : 2 year

D : six month

Answer: D

Question 3

The total resistivity for a Wenner 4-Pin test that utilizes pins spaced 2 feet apart and a 6 “R” factor is:

Options :

A : 2298 ohm/cm

B : 3500 ohm/cm

C : 6000 ohm/cm

D : 8000 ohm/cm

Answer: A

Question 4

A blank is required between two NPS 10, 300 lb. class flanges. The maximum pressure in the system is 385 psi at 200 degrees F. A corrosion allowance of 0.175" is required. The inside diameter of the gasket surface is 9.25". The blank is ASTM A516 Grade 70 material with no weld joint. Calculate the pressure design thickness required for the blank

Options :

A : 0.789"

B : 0.692"

C : 0.556

D : 0.768"

Answer: B

Question 5

Undercut is normally found_______________.

Options :

A : in the weld metal

B : in the base metal

C : at the weld interface

D : at the root of the weld, only

Answer: C

Higher Test Marks with Free Online API-570 Exam Practice

Buying Options: