Question 1

Which statement best describes a key difference between Lean and Six Sigma?

Options :

A : Six Sigma uses value-stream mapping, whereas Lean uses 5S.

B : Lean is a data-driven approach, whereas Six Sigma focuses on team collaboration.

C : Lean emphasizes speed and efficiency, while Six Sigma focuses on quality and precision.

D : Six Sigma aims to eliminate waste, whereas Lean targets process improvement.

Answer: C

Question 2

In a CMM, a touch-trigger probe is used to:

Options :

A : Determine the color and texture of the object.

B : Measure the hardness of the object being measured.

C : Continuously scan the surface of an object.

D : Collect data points when the probe makes contact with the object-s surface.

Answer: D

Question 3

If a corrective action fails to resolve a problem permanently, this often indicates that:

Options :

A : The problem was too complex for RCA.

B : Containment actions were inadequate.

C : The RCA was not conducted thoroughly.

D : The problem is unsolvable.

Answer: C

Question 4

If the MRB decides to scrap a nonconforming material, this indicates that:

Options :

A : The material can be used for a different product.

B : The material will be stored for future evaluation.

C : The nonconformity is minor and does not affect the product-s use.

D : The nonconformity cannot be rectified, and the material cannot be used safely or effectively.

Answer: D

Question 5

When the MRB decides to 'use as is' for a nonconforming material, it implies that the material:

Options :

A : Will be reworked to meet the minimum acceptable standards.

B : Will be returned to the supplier for replacement.

C : Meets all quality standards without exception.

D : Is suitable for its intended purpose despite the nonconformity.

Answer: D

Higher Test Marks with Free Online CQT Exam Practice