Question 1

Which statement about protocol options is true?

Options :

A :

Protocol options allow administrators to configure a maximum number of sessions for each configured protocol.

B :

Protocol options give administrators a streamlined method to instruct FortiGate to block all sessions corresponding to disabled protocols.

C :

Protocol options allow administrators to configure the Any setting for all enabled protocols, which provides the most efficient use of system resources.

D :

Protocol options allow administrators to configure which Layer 4 port numbers map to upper-layer protocols, such as HTTP, SMTP, FTP, and so on.

Answer: D

Question 2

Refer to the exhibit, which shows the output o! the BGP database.

Which two statements are correct? (Choose two.)

Options :

A : The advertised prefix of 10.20.30.0'24 was configured using the network command.

B : The first four prefixes are being advertised using a legacy route advertisement.

C :

The advertised prefix of 10.20.30.0'24 is being advertised through the redistribution of another routing protocol.

D : The output shows all prefixes advertised by all neighbors as well as the local router.

Answer: A,D

Question 3

Refer to the exhibit, which shows partial outputs from two routing debug commands.

Which change must an administrator make on FortiGate to route web traffic from internal users to the internet, using ECMP?

Options :

A : Set snat-route-change to enable.

B : Set the priority of the static default route using port2 to 1.

C : Set preserve-session-route to enable.

D : Set the priority of the static default route using port1 to 10.

Answer: D

Question 4

Exhibit.

Refer to the exhibit, which shows the output of diagnose automation test.

What can you observe from the output? (Choose two.)

Options :

A : The automation stitch test is not being logged.

B : The automation stitch test failed but the HA failover was successful.

C : An HA failover occurred.

D : The test was unsuccessful.

Answer: A,D

Question 5

Refer to the exhibit, which shows the output of a debug command.

Which two statements about the output are true? (Choose two.)

Options :

A : The interlace is part of the OSPF backbone area.

B : There are a total of five OSPF routers attached to the vorz4 network segment

C : One of the neighbors has a router ID of 0.0.0.4.

D : In the network connected to port4, two OSPF routers are down.

Answer: A,D

Higher Test Marks with Free Online FCSS_NST_SE-7.4 Exam Practice

Buying Options: