Question 1

What are two reasons you might see iprope_in_check() check failed, drop when using the debug flow? (Choose two.)

Options :

A : Packet was dropped because of policy route misconfiguration.

B : Packet was dropped because of traffic shaping.

C : Trusted host list misconfiguration.

D : VIP or IP pool misconfiguration.

Answer: C,D

Question 2

Refer to the exhibit, which shows the output of a debug command.Which two statements about the output are true? (Choose two.)

Options :

A : The interlace is part of the OSPF backbone area.

B : There are a total of five OSPF routers attached to the vorz4 network segment

C : One of the neighbors has a router ID of 0.0.0.4.

D : In the network connected to port4, two OSPF routers are down.

Answer: A,D

Question 3

Refer to the exhibit, which shows the output of diagnose sys session list.If the HA ID for the primary device is 0, what happens if the primary fails and the secondary becomes theprimary?

Options :

A : The secondary device has this session synchronized; however, because application control is applied, the session is marked dirty and has to be re-evaluated after failover.

B : Traffic for this session continues to be permitted on the new primary device after failover, without requiring the client to restart the session with the server.

C : The session will be removed from the session table of the secondary device because of the presence of allowed error packets, which will force the client to restart the session with the server.

D : The session state is preserved but the kernel will need to re-evaluate the session because NAT was applied.

Answer: B

Question 4

Refer to the exhibit, which shows the omitted output of a session table entry.Which two statements are true? (Choose two.)

Options :

A : The traffic has been tagged for VLAN 0000.

B : NP7 is handling offloading of this session.

C : The traffic matches Policy ID 1.

D : The session has been offloaded.

Answer: B,D

Question 5

Which statement about IKEv2 is true?

Options :

A : Both IKEv1 and IKEv2 share the feature of asymmetric authentication.

B : IKEv1 and IKEv2 have enough of the header format in common that both versions can run over the same UDP port.

C : IKEv1 and IKEv2 use same TCP port but run on different UDP ports.

D : IKEv1 and IKEv2 share the concept of phase1 and phase2

Answer: B

Higher Test Marks with Free Online FCSS_NST_SE-7.6 Exam Practice

Buying Options: