Question 1

You are configuring VSX active gateway on CX 8360 campus aggregation switches when the switch prompt returns the following error: "No more than IB VMACs can be configured." What should be done to address this issue?

Options :

A : Limit the number of SVIs with active-gatewayto 16.

B : Change the switch profile to ‘’Leal’’ to increase the number of supported vMACs.

C : Change the aggregation switch to a higher-end model, such as a CX 8400.

D : As MAC addresses are link-local, use the same VMAC across SVIs.

Answer: D

Question 2

Aplying the command "ip Igmp snooping blocked VLAN 6. 6* on a port ...

Options :

A : won't prune multicast on that port on VLAN 5 and 6

B : won't accept multicast Igmp joins on that port or VLAN 5 and 6.

C : won't allow multicast traffic between VLAN 5 and 6.

D : won't allow multicast on that port in VLAN 5 and 6 and disables the port.

Answer: B

Question 3

A pair of CX 8325 series switches a configured in a VSX cluster. Which function is executed on both VSX members during normal operation?

Options :

A : replies to ARP requests with thecluster vMAC

B : routes PIM and PIM-DR

C : relays DHCP requests or serves DHCP offer

D : periodically sends gratuitous ARP and broadcast hello packets

Answer: A

Question 4

the administrator of a largo company noticed thatthere are some problems with UCC sessions on a wired network. Some employees complain about dropped calls and poor quality. The administrator wants to monitor, jitter on AOS-CX switches with iP SLA. but notices results spiking to 100% What should the administrator check first to correct monitoring to run as desired?

Options :

A : memory and processor usage

B : source IP and source port combination

C : number of NAE agents

D : CoPP settings

Answer: A

Question 5

Review the diagram and existing configuration of RouterA above. Which configuration changes are necessary

to permit load balancing between RouterA and RouterB? (Selecttwo)

Exhibit.