Question 1

According to Nutanix best practices, which interface configuration should be used when setting up the default bond?

Options :

A : One 10G uplink only

B : 10G uplinks only or 25G uplinks only

C : One 10G uplink paired with one 25G uplink

D : One 1G uplink paired with one 10G uplink

Answer: B

Question 2

An administrator needs to make sure an RF2 cluster can survive a complete rack failure without negatively

effecting workload performance. The current cluster configuration consists of thefollowing:

• 30 nodes: distributed 10 nodes per rack across three 42U rack

• Each nodes is configured with 40TB usable storage all flash (Cluster Total 1.2 PB Usable)

• Current cluster utilization is 900TB storage

Which configuration changes should be made to make sure that the cluster meets the requirements?

Options :

A : Expanse the cluster by adding 3 additional nodes per rack, 9 nodes total.

B : Expanse the cluster by adding 2 additional nodes per rack, 6 nodes total.

C : Expanse thecluster by adding 9 nodes to a new 42U rack

D : Expanse the cluster by adding 8 nodes to a new 42U rack

Answer: A

Question 3

A systems administrator configures a protection domain replication between two Nutanix clusters. After the

first successful replication , the administrator tests DR by clicking activate on the remote cluster.

While VMs are active on the remote cluster, the protection domain is marked as active on both clusters.

What steps are required to return both clusters to their original state?

Options :

A :

1. On the remote site, deactivate the Protection Domain using ncli

2. On the primary site, select theProtection Domain and dick migrate

B :

1. On the remote site, promote the Protection Domain

2. On the primary site, change the Protection Domain state from Decoupled to Disabled

3 Enable the original primary site as remote site

C :

1. On the prima7 site,suspend replications

2. On the remote site, deactivate the Protection Domain using ncli

3. On the remote site, migrate the protection domain back to the primary site

D :

1 On the remote site, restore the snapshots from the Protection Domain

2. On the remote site, select the Protection Domain and migrate to the primary site

Answer: C

Question 4

Refer to the exhibits.

An administrator has reported that a new VM is not performing well.

After analyzing the information presented in the exhibits, which option shows the best conclusion regarding this workload?

Options :

A : VM is CPU constrained since the hypervisor cannot provide the required resources.

B : VM is CPU constrained because more CPU needs to be added to the VM.

C : VM is Storage constrained, because the workload is waiting for storage access.

D : VM is not CPU constrained, because the VM is not running, a multithreaded application.

Answer: C

Question 5

An administrator inherits a new Nutanix environment and logs in to a CVM to check the network configuration. The configuration is as follows:

Which action should the administrator take to improve network performance?

Options :

A : Configure VLAN tagging both on br0 and br1 and their physical interfaces.

B : Add eth0 and eth1 to the br0-up bond

C : Configure balance-sib or balance-tcp mode for br0-up if switch configuration allows

D : Remove one 10 Gbs interface from br0-up to make sure all 10 Gbs can be used.

Answer: C

Higher Test Marks with Free Online NCS-Core Exam Practice

Buying Options: