Question 1

You installed a new 4-node AFF A400 ONTAP 9.8 cluster. The AFF400 controller data ports were automatically

discovered by “automatic port placement”.

In this scenario, which two ONTAP network settings were automatically configured? (Choose two.)

Options :

A : routes

B : IPspaces

C : broadcast domains

D : subnets

Answer: B,C

Question 2

Click the Exhibit button.

You are preparing to replace a Cisco Nexus 92300YC switch. You have executed the cluster pingcluster node1 command and received the output as shown in the exhibit.

Which two checks indicate that the cluster is ready for the replacement to be performed? (Choose two.)

Options :

A :

2 paths up, 0 paths down (TCP check)

B : 2 paths up, 0 paths down (UDP check)

C : larger than PMTU communication succeeds on 4 path(s)

D : basic connectivity succeeds on 4 path(s)

Answer: C,D

Question 3

You have a 2-node FAS8300 ONTAP 9.8 cluster that serves SMB shares. You are configuring interface groups

for higher performance and resiliency.

Which two NetApp best practices should you follow to satisfy these performance and resiliency requirements?

(Choose two.)

Options :

A : Use ports from different NICs.

B :

Use ports from the same NICs.

C : Use ports with different chipsets.

D :

Use ports with the same chipsets.

Answer: A,D

Question 4

You have completed a base installation and system registration of an AFF A250 system, but you notice that you

have one failed drive. Neither “un-failing” nor reseating the drive helped to repair it. You must ensure proper

replacement of the failed drive.

In this scenario, which two actions should you take? (Choose two.)

Options :

A :

Ask the customer to open a technical case with NetApp Support.

B :

Ask the customer for a drive with the same capacity and replace it.

C : Run Active IQ Config Advisor to collect all the logs on the system.

D :

Power off the system until the drive has been replaced.

Answer: A,C

Question 5

You are expanding an existing cluster that uses BES-53248 cluster interconnect switches. You connected the new controllers to ports 0/17 through 0/20. However, you are unable to join the new nodes to the cluster. Which action must be taken to solve the problem?

Options :

A : Install the license file.

B : Install the CSHM configuration file.

C : Install the reference configuration file.

D : Reboot the controllers.

Answer: A

Higher Test Marks with Free Online NS0-184 Exam Practice

Buying Options: