Question 1

Refer to the exhibit

Examine the sections of the configuration shown in the output What action will FortiGate take when verifying the student certificate through OCSP?

Options :

A : Reject the student certificate if the OCSP server replies that the student certificate status is unknown

B : Not verify the OCSP server certificate

C : Use the OCSP URL included in the student certificate to verify the student certificate

D : Consider the student certificate status as valid if the OCSP server is unreachable

Answer: A

Question 2

Refer to the exhibits

The exhibits show the wireless network (VAP) SSID profiles defined on FortiManager and an AP profile assigned to a group of APs that are supported by FortiGate None of the APs are broadcasting the SSlDs defined by the AP profile Which changes do you need to make to enable the SSIDs to broadcast?

Options :

A : In the SSIDs section enable Tunnel

B : Enable one channel in the Channels section

C : Enable multiple channels in the Channels section and enable Radio Resource Provision

D : In the SSIDs section enable Manual and assign the networks manually

Answer: B

Question 3

Refer to the exhibit.

Examine the IPsec VPN phase 1 configuration shown in theexhibit An administrator wants to use certificate-based authentication for an IPsec VPN user Which three configuration changes must you make on FortiGate to perform certificate-based authentication for the IPsec VPN user? (Choose three)

Options :

A :

Create a PKI user for the IPsec VPN user, and then configure the IPsec VPN tunnel to accept the PKI user as peer certificate

B :

In the Authentication section of the IPsec VPN tunnel in the Method drop-down list select Signature and then select the certificate that FortiGate will use for IPsec VPN

C : In the IKE section of the IPsec VPN tunnel in the Mode field select Main (ID protection)

D : Import the CA that signed the user certificate

E : Enable XAUTH on the IPsec VPN tunnel

Answer: B,D,E

Question 4

An administrator is deploying a new FortiGate device using zero-touch provisioning. Before deployment, the administrator added the FortiGate serial number on FortiManager and configured all the FortiGate settings FortiGate has a factory default configuration. However, when the administrator connects FortiGate to the network, FortiManager does not start the installation automatically. Which two scenarios are likely to cause this issue? (Choose two.)

Options :

A : The serial number added on FortiManager does not match the FortiGate serial number.

B : The DHCP server that serves FortiGate is not configured with options 240 and 241.

C : Zero-touch provisioning is disabled on FortiManager.

D : The pre-shared key set on FortiManager does not match the one set on FortiGate.

Answer: A,B

Question 5

Which CLI command should an administrator use to view the certificate verification process in real time?

Options :

A : diagnose debug application foauthd -1

B : diagnose debug application radiusd -1

C : diagnose debug application authd -1

D : diagnose debug application fnbamd -1

Answer: A

Higher Test Marks with Free Online NSE7_LED-7.0 Exam Practice

Buying Options: